Motion/Auxiliary Relays - Harmony eXLhoist User Manual

Motion/Auxiliary Relays

Description
The motion/auxiliary relays are switched ON as long as the associated button is pressed.
Only up to 6 motion/auxiliary relays activation occurs at the same time.
If more than 6 motion/auxiliary relays switching are requested at the same time, then they are
actuated in successive switching every 20 ms (except for UOC relays).
You can configure the motion/auxiliary relays with the eXLhoist Configuration Software
(see page 194).
General Wiring Rules
The I/O and power supply cables should be AWG 16 (cross-sectional conductor area = 1.3 mm
The I/O and power supply cable lengths should not exceed 20 m (65.6 ft).
For more details, refer to Wiring Best Practices
Wiring
Q1...Q9 motion relay internal wiring (NO type):
EIO0000001505 12/2014
(see page 91).
Installation and Wiring
2
).
99