Power On - Harmony eXLhoist User Manual

Using The Wireless Remote Control System

Power ON

Overview
The aim is to describe how to power ON the Wireless Remote Control System.
Triggering Procedure
Step Action
1 Check that the Remote Device is powered OFF.
2 Power ON the Base Station.
3 Press only the ON/START/Horn button more or equal than 1 s.
Result: The Remote Device is powered ON.
The discovery procedure is automatically launched. If the Wireless Remote Control System has
been installed correctly, the Wireless Remote Control System goes automatically in STOP mode
(see page 123).
In other case, refer to the discovery description
Release
The Remote Device is powered OFF:
By the Power OFF procedure

Automatically when the Remote Device battery level is too low.

Automatically after the Power-saving time-out. You can configure the Power-saving time-out in

the XAR Configuration software
120
(see page
(see page 128).
(see page 193).
137).
EIO0000001505 12/2014