Toolbar - Harmony eXLhoist User Manual

eXLhoist Configuration Software

Toolbar

Introduction
The toolbar is a panel at the top of the main window which provides access to the main commands
using icons.
The toolbar can be turned on or off by selecting View → Toolbar from the menu bar.
Description
The illustration shows the eXLhoist Configuration Software toolbar:
Element Description
1 Go to Start Page: Displays the start page, any opened project must be closed. If the project is
not saved, a dialog box asks to save the project.
2 New Project: Creates new project, any opened project must be closed. If the project is not
saved, a dialog box asks to save the project.
3 Open Project: Opens a project saved on your computer.
4 Save: Saves modifications to an existing project.
5 Save As: Saves an open project under a name and/or in a new location.
6 Page Setup: Ables to configure the printing page setup.
7 Print Preview: Displays the print preview.
8 Print: Prints the project.
9 Identify Device
10 Edit Connection
11 Connect to Device: Establishes the connection between the remote and the software.
12 Disconnect from Device: Disconnects the connection between the remote and the software.
13 Load From Device: Loads the parameters from the connected remote to the project file.
If no project is opened, this command loads the remote information to the project file.
If a project is opened, this command loads the remote configuration to the project. Project data
are overwritten.
14 Store to Device: Transfer configuration from project to the remote.
If no project is opened, this command downloads the existing project file information to the
remote.
If a project is opened, this command transfers the project information to the remote.
172
(see page 189)
(see page 182).
EIO0000001505 12/2014