Start - Harmony eXLhoist User Manual

START

Overview
The START mode is the only mode in which:
You can command the motions

You can command the auxiliary function

You can command the horn

The safety relays are switched ON.

Triggering Procedure
Required conditions: The Wireless Remote Control System must be in STOP mode.
Triggering procedure:
Step Action
1 If a START code sequence is configured:


2 Press only the ON/START/Horn button more or equal than 1 s.
3 Wait during the START warning time (ZART•D vibrations, "Horn" relay ON).
START Details
It is recommended to use a Schneider Electric beacon:
1 Light wired to the "Radio link" relay
2 Light wired to the "Safety relay image" relay
3 Buzzer wired to the "Horn" relay (an additional flash light can be wired to this relay)
EIO0000001505 12/2014
(see page
(see page
Type the START code sequence with the motion buttons 1, 2, 3, 4, 5, 6.
The default START code sequence is 5, 6, 5, 6.
Press the button 7 (trigger) to validate.
Using The Wireless Remote Control System
131).
(see page 133).
136).
125