How To Modify The Configuration; How To Modify A Configuration - Harmony eXLhoist User Manual

Using The Wireless Remote Control System
Section 5.4

How to Modify the Configuration

How to Modify the Configuration

How to Modify a Configuration

Configuration Modification
The following procedure describes how to modify the system configuration:
Step Action
1 Connect the Remote Device to a PC
2 Start the eXLhoist Configuration Software
3 Create a project
4 Modify the configuration of the project
5 Select Communication → Store to Device.
6 Wait for the end of the Configuration File load in the Remote Device.
7 Disconnect the Remote Device to the PC.
8 Power ON the Base Station.
9 The Configuration File must be loaded from the Remote Device to the Base Station.
Refer to:


Result: The Remote Device goes to STOP mode
It is recommended to redo an Acceptance Test
Configuration File load With a ZART8L
After the modification of the configuration with the eXLhoist Configuration Software:
Step Action
1 Power ON the Remote Device.
2 The Configuration File is automatically loaded from the Remote Device to the Base Station.
During the load, the START LED and "2" LED are flashing
Wait for the end of the Configuration File load.
Result: The Remote Device goes to STOP mode
It is recommended to redo an Acceptance Test
140
(see page
Configuration File load With a ZART8L
Configuration File load With a ZART•D
(see page 165).
(see page
179).
(see page 188)
(see page
(see page
(see page
(see page
(see page
(see page
178).
140).
141).
123).
75).
(see page 157) .
123).
75).
EIO0000001505 12/2014