Selector - Harmony eXLhoist User Manual

Installation and Wiring

Selector

Description
In SINGLE configuration, the Selector button is associated to 2 relays.
With an adapted wiring, these relays enable/disable the motions of the selected device
(hook/trolleys).
In TANDEM configuration, no relays are associated with the selector button. The button is used to
select directly which Base Station are piloted.
You can configure the selector with the eXLhoist Configuration Software
General Wiring Rules
The I/O and power supply cables should be AWG 16 (cross-sectional conductor area = 1.3 mm
The I/O and power supply cable lengths should not exceed 20 m (65.6 ft).
For more details, refer to Wiring Best Practices
102
(see page 91).
(see page 194).
EIO0000001505 12/2014
2
).