Diagnostic Mode - Harmony eXLhoist User Manual

Diagnostic

Diagnostic Mode

Overview
To test the Wireless Remote Control System configuration, the ZART•D has a specific diagnostic
mode display.
Procedure to Activate the Diagnostic Mode
The diagnostic mode on the ZART•D indicates the inputs and relays states of the Base Station.
Step Action
1 Go to STOP mode
2 Simultaneously press the buttons 1 and 2, and release immediately.
3 Less than 5 seconds later, simultaneously press the buttons 3 and 4.
4 Release the buttons 3 and 4.
Diagnostic Display Description
In STOP mode, use the buttons 5 and 6 to alternate between the 3 screens:
Base Station information:

ID

Hardware version

Firmware version

Remote Device information:

ID

Hardware version

Firmware version

Remote Device battery information (only for Schneider-Electric use).

In START mode, the Remote Device displays dynamically the I/O status:
1 IN1...IN18 states: up for input = 1, down for input = 0
2 Relays 1...18 states: up for output = 1, down for output = 0
150
(see page 123).
EIO0000001505 12/2014