Special Functions - Harmony eXLhoist User Manual

Special Functions

Description
The Wireless Remote Control System manages 4 specific relays:
Relay
Horn
Radio link
Safety relay
image
Tandem 1+2
You can configure the specific relays with the eXLhoist Configuration Software
Application Example
A "Radio link" indication shall inform operator about the system communication status according
to EN 15011 standard.
It is recommended to use a Schneider Electric beacon:
1 Light wired to the "Radio link" relay
2 Light wired to the "Safety relay image" relay
3 Buzzer wired to the "Horn" relay (an additional flash light can be wired to this relay)
The beacon operating is described in the START mode description
EIO0000001505 12/2014
Description
This relay is switched ON during the start procedure, and for a configurable duration.
This relay is also switched ON, in START mode, as long as the ON/START/Horn is pressed.
This relay is switched ON as long as a RADIO communication is achieved between the Base
Station and its Remote Device.
This relay is switched ON as long as the 2 safety relays are ON.
It occurs only in START mode and if all the safety conditions are fulfilled.
It can indicate when the motions are enabled.
This relay is switched ON only in TANDEM configuration and only when the 2 Base stations
are selected.
This relay can be used in case of inhibition of anticollision in TANDEM configuration.
Installation and Wiring
(see page
(see page 125).
194).
109