Applicative Alarms Signals - Harmony eXLhoist User Manual

Applicative Alarms Signals

Overview
Some devices can be connected to the ZARB18• Base Station to provide detected applicative
alarms signals that can be displayed in the ZART•D.
ZART•D
When applicative alarms signals come from ZARB18• Base Station, the ZART•D Remote Device
involves a symbol display and 3 seconds of vibration every 10 minutes as long as the alarm signal
is active.
The Remote Device displays the following symbols:
Display Status
Permanently ON
Blinking at a frequency of 1 Hz
Permanently ON
Blinking at a frequency of 1 Hz
Blinking at a frequency of 1 Hz
Blinking at a frequency of 1 Hz
NOTE: The applicative alarms are only information, the Wireless Remote Control System does not
change its functional mode.
EIO0000001505 12/2014
Description
Overload pre-alarm
Overload alarm
Over wind pre-alarm
Over wind alarm
Over speed alarm
Generic alarm
Diagnostic
155