Table of Contents
Advertisement
Chapter 6: Peripheral Devices & Accessories
Battery Charging – LED Behaviour
If a link is established between NEO and a host, the application on the host and on the hand-
held must have a recovery mechanism in the event that NEO is removed from the dock and
the link is interrupted.
6.8.5
Battery Charging – LED Behaviour
Charge status is displayed on the hand-held LED. Refer to Table 6.3 on page 159 for
detailed LED charge behaviour. When inserted in the quad dock, NEO requires 3 hours to
charge to charge the battery to 75% capacity. Charge durations are independent of the
number of NEOs docked.
Note: The specified battery charge times are based on NEO being powered off. Additional
peripherals and other power consumption features will also alter the specified
charge time.
6.8.6
Troubleshooting
The indicators, applications and drivers required to use and monitor the docking station are
installed on NEO – no indicators or applications are present on the docking station itself.
6.8.6.1 Network Link Unsuccessful
If a network link fails, the application must take appropriate action.
6.8.6.2 NEO LED Does Not Light When Docked
•
Check that the quad docking station has power: Is the Power LED on the docking
station illuminated?
•
Try inserting NEO in another well in the quad dock.
•
Check for dirt or contamination on the docking contacts at the bottom of NEO. Wipe the
contacts with a damp cloth if necessary.
•
Check the connector pins inside the dock cradle for dirt. Gently wipe with a soft cloth if
they appear to be dirty or discoloured.
•
Check that the contacts are not bent or damaged.
•
Remove and reinsert NEO in the cradle.
•
Make certain that the battery installed in NEO is not defective.
6.9
Scanners and Imagers
NEO supports 1D laser scanner (SE955), 2D imager (HHP 5000) and 1D imager (EV15)
options to address a variety of user application requirements. The scanner installed in your
164
Psion Teklogix NEO Hand-Held Computer User Manual
Advertisement
Table of Contents
Troubleshooting
