Table of Contents
Advertisement
Appendix C: Bar Code Settings
UPC A
C.1.9
UPC A
Enabled
Set this parameter to on to enable UPC A.
UPC-A Check Digit
If you enable this parameter, the check digit is included with the decoded bar code data.
UPC-A Preamble
When you double-tap on this parameter, a dialog box is displayed where you can choose one
of three options for lead-in characters for UPC-A symbols transmitted to the host device:
System Char – system character transmitted with the data,
Country Code and System Char – both the country code ("0" for USA) and system char-
acter are transmitted with the data, or
None – no preamble is transmitted. The lead-in characters are considered part of the symbol.
Add/Remove Data
Refer to "Add/Remove Data" on page 8 for details.
C.1.10
UPC E
Enable UPC-E
Set this parameter to on to allow UPC E bar code scans.
Enable UPC-E1
Set this parameter to on to allow UPC-E1 (zero suppressed) bar code scans.
UPC-E and UPC-E1 Check Digit
If you enable one or both of these parameters, a check digit is included with the decoded bar
code data.
UPC-E and UPC-E1 Preamble
When you double-tap on one of these parameters, a dialog box is displayed where you can
choose one of three options for lead-in characters for UPC-E and UPC-E1 symbols trans-
mitted to the host device:
System Char – system character transmitted with the data,
C-10
Psion Teklogix NEO Hand-Held Computer User Manual
Advertisement
Table of Contents
Troubleshooting
