3. PHYSICAL INSTALLATION
About this chapter
This chapter describes how the mechanical and electrical set up of the projector has to be done.
Overview
•
Positioning the B-series projector at port window
•
Installation of the exhaust system
•
Access to the power connection
•
Connecting the DPxK-19B/23B/P with the power net
•
Power loop through to the projector electronics
•
Connecting a UPS to the projector electronics
3.1
Positioning the B-series projector at port window
W
ARNING
General guide lines
•
Use a solid pedestal to put the B-series projector on. Ensure that the pedestal can handle the weight of the projector and that
all feet of the projector are captured.
•
The pedestal should be placed in front of the port window wall in a manner that the projector front cover is at a minimum distance
of 20 centimeters from the port window.
Image 3-1
Positioning at port window
Barco offers a pedestal for the B-series projector. This universal pedestal allows a solid and easy setup of
the projector. The universal pedestal has a separate compartment to install the UPS unit (if available) for the
B-series projector. Futhermore, the universal pedestal contains a standard 19" rack to build in the projector
peripherals like alternative content switchers (e.g. ACS-2048).
Necessary tools
•
14 mm wrench
•
17 mm wrench
Projector centering
1. If the projector is standalone in front of the port window, center the projector with the theatre screen (see ref A image 3-2).
R5905067 DPXK-19B/23B/P 17/09/2012
:
The installation of the B-series projector requires at least 4 persons.
20 cm
3. Physical installation
17