Ⅲ . OPERATION
1. CONFIGURATION OF THE OPERATION PANEL
❶
❹
❷
❸
❶ Re-sewing switch
❷ Teaching switch
❸ Needle up/down compensating
switch
❹ Screen changeover switch
❺ With/without reverse feed stitch at
sewing start switch
❻ With/without reverse feed stitch at
sewing end switch
Switch
Re-sewing switch
❶
Teaching switch
❷
Needle up/down compensat-
❸
ing switch
Screen changeover switch
❹
With/without reverse feed
stitch at sewing start switch
❺
With/without reverse feed
stitch at sewing end switch
❻
❺
❻
❼ Material edge sensor switch
❽ One-shot automatic sewing
switch
❾ With/without automatic thread trim-
mer switch
Thread trimming prohibiting
switch
Backlight switch
This switch is used to continue sewing from the step on the way
after replacing bobbin thread when bobbin thread has run out
during program stitching step.
This is the switch to set the setting of the number of stitches with
the value of number of stitches which has been actually sewn.
This is the switch to perform needle up/down compensating stitching.
(Needle up/down compensating stitching and one stitch compensating
stitching can be changed over with function setting No. 22.)
This is the switch to change over the screen.
This is the switch to turn ON/OFF automatic reverse feed stitch at
sewing start.
* This switch cannot be used with the sewing machine which is
not provided with automatic reverse feed stitching device.
This is the switch to turn ON/OFF automatic reverse feed stitch at
sewing end.
* This switch cannot be used with the sewing machine which is
not provided with automatic reverse feed stitching device.
– 19 –
❽
❼
❾
Reset switch
Information switch
+ switch
- switch
Counter/speed changeover switch
General-purpose switch
Power display lamp
Description