Operating The Work Management Screen; Work Management Screen - JUKI IT-100 Instruction Manual

5-2. Operating the work management screen

(1) work management screen

On the work management screen, work data such as the operator ID, product number and process number,
whch are to be embedded n the operaton data recorded by each sewng machne are entered and man-
aged. In addton, the recoded operaton data can be uploaded. Furthermore, on the work management
screen, operatons requred for procedures such as count-up of the producton volume and stoppng of mea-
surement can be carred out. Ths means that sewng work can be done wth ths screen dsplayed.
* Refer to "#. 5-1. How to change over the screen under the normal sewing mode"
cedure to be taken until this screen is displayed.
1
Switch/display
Manual swtch
1
Product number selecton swtch
2
Operator ID selecton swtch
3
Optonal ID selecton swtch
4
No. of pcs. n lot settng swtch
5
Measurement changeover swtch
6
Communcaton selecton swtch
7
A Dsplay of the current tme of day
B Dsplay of the latest ptch tme
C Dsplay of the producton volume
A B C
5
2 3 4
A press on ths swtch ncreases the number of sewn peces by one.
Ths swtch s used to dsplay an abbrevated number for the selected prod-
uct number.
When ths swtch s pressed, the sewng product's product number nput
screen s dsplayed. Refer to
ber input screen".
Ths swtch s used to dsplay an abbrevated number for the selected op-
erator ID.
When ths swtch s pressed, the operator ID selecton popup screen s ds-
played. Refer to
Ths swtch s used to dsplay an abbrevated number for the selected op-
tonal ID.
When ths swtch s pressed, the optonal ID selecton screen s dsplayed.
Refer to "#-5-2. (4) Optional Id selection
In the case of the lot producton, the number of peces n a lot can be
counted collectvely. The total number of peces n a lot should be entered.
When ths swtch s pressed, the No. of pcs. n lot nput screen s dsplayed.
"#-5-2. (5) No. of pcs. in lot setting
Refer to
Ths swtch s used to stop measurement and recordng of the sewng ma-
chne operaton data.
* Measurement s carred out (state):
* Measurement s stopped: Sewng machne startup s stopped (state):
Ths swtch s used to upload measurement data.
When the swtch s pressed, the communcaton selecton screen s ds-
played. Refer to
The current tme of day s dsplayed.
The tme perod between two tmes of thread trmmng s measured and
dsplayed.
The producton volume under sewng work s dsplayed.
6
7
description
"#-5-2. (2) Sewing product's product num-
"#-5-2. (3) Operator Id selection
"#-5-2. (6) Communication selection
– 49 –
for the operating pro-
screen".
screen".
screen".
screen".