JUKI IT-100 Instruction Manual page 59

Explanation of displayed information and operating switches on the pitch time monitor screen No. 1
(pitch time graph mode)
Switch/display
A Ptch tme graph dsplay
B Cursor dsplay
C Contnuous secton dsplay
D Cursor ptch tme dsplay
E Dsplay of the producton vol-
ume n a cursor secton
F Latest ptch tme dsplay
Producton volume count-up
1
swtch
Functon selector swtch
2
Functon shftng swtch
3
Graph scroll swtch
4
Dsplay changeover swtch to
5
dsplay the ptch tme montor
screen No. 2
Producton volume counter cor-
6
recton swtch
A graph vertcal axs of whch represents the producton volume and hor-
zontal axs of whch represents the ptch tme s dsplayed.
The ranges of the vertcal and horzontal axes can be set on the ptch
tme montor screen No. 2.
The locaton of the cursor s dsplayed.
The contnuous secton set on the graph s dsplayed.
The total producton volume and average ptch tme n a contnuous sec-
ton selected on the ptch tme montor screen No.2 can be checked.
The pitch time in the section specified by the cursor on the graph is dis-
played.
The producton volume n the secton specfed wth the cursor on the
graph s dsplayed.
The length of tme between two tmes of thread trmmng s measured
and dsplayed.
* If the ptch tme s equal to or longer than 00 seconds (30 mnutes), t
wll be regard as defectve data and ---- wll be dsplayed nstead of the
ptch tme.
The producton volume s counted up wth one tem added.
The cursor or the contnuous secton selecton (begnnng and end) s se-
lected.
Selected functon s shfted to the rght or left.
When ths swtch s pressed shortly, the graph s scroll to the rght or left
by one secton.
When ths swtch s held pressed for a longer tme, the graph s scrolled
to the rght or left on a page-by-page bass.
The ptch tme montor screen No. 2 s dsplayed.
The producton volume can be corrected by ncreasng/decreasng the
number shown on the counter n ncrements of .
– 5 –
description