JUKI IT-100 Instruction Manual page 66

Explanation of displayed information and operating switches on the production management screen
No. 1
Switch/display
A Dsplay of method to cal-
culate the target produc-
ton volume
B Target producton volume ds-
play
C Actual producton volume ds-
play
D Delay/progress dsplay
E Target ptch tme dsplay
F Latest ptch tme dsplay
G Achevement rato dsplay
H Daly target producton
volume dsplay
Producton volume count-
1
up swtch
Daly target producton
2
volume settng swtch
Actual producton volume
3
clear swtch
Measurement stop swtch
4
Dsplay changeover swtch
5
to dsplay the producton
management screen No. 2
Producton volume counter
6
correcton swtch
The method to calculate the currently selected target producton volume s ds-
played.
: Count-up by the ptch tme
to : Count-up by the beginning/finishing times of day of work and
the total producton volume
The target producton volume as of the current tme s dsplayed.
The actual producton volume s dsplayed.
s dsplayed when the actual producton volume as of the current tme s
smaller than the target producton volume, or
equal to or larger than the latter one.
The target ptch tme for countng up the target producton volume accordng to the
lapse of tme s dsplayed.
: In the case of count-up by the ptch tme, the ptch tme that s set on
the producton management functon settng screen s dsplayed.
to : In the case of count-up by the beginning/finishing times of day
of work and the total producton volume, the ptch tme calculated from
the workng hours and total producton volume are dsplayed.
Length of tme between two tmes of thread trmmng s measured and dsplayed.
* If the ptch tme s equal to or longer than 00 seconds (30 mnutes), t wll be
regarded as defectve data and ---- wll be dsplayed nstead of the ptch tme.
The rato of the actual producton volume to the target producton volume as of the
current tme s dsplayed.
It allows the operator to know hs/her work pace up to the present
The daly target producton volume correspondng to the currently selected target
producton volume calculaton method s dsplayed.
The producton volume s counted up wth one tem added.
The daly target producton volume s set.
* When the swtch s pressed, the numerc nput popup screen s dsplayed. Input
a set value n the popup screen.
The actual producton volume s cleared.
On every workng day, the exstng actual producton volume should be cleared
before startng work.
Measurement and recordng of sewng machne operaton data are stopped.
When measurement s beng carred out,
When measurement s n the stop status,
The producton management screen No. 2 s dsplayed.
The producton volume can be corrected by ncreasng/decreasng the number
shown on the counter n ncrements of .
– 3 –
description
s dsplayed when the former s
s dsplayed.
s dsplayed.