Simplified Function Setting - JUKI IT-100 Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

4-10. Simplified function setting

wARNING :

If the solenoid is used under the air drive mode, the solenoid can burn out. Be sure to carefully avoid

the wrong setting of the presser foot lifting device specification.

Function setting items can be simplified in part.

[Simplified function setting screen]

■ wiper function (wip): Switches 2 and 3

Ths functon actvates the wper.

oFF

: The wper does not operate after thread trmmng.

The wper does not operate after thread trmmng.

: The w

The wper operates after thread trmmng (standard settng at the tme of delvery)

■ Auto-lifter (fL): Switches 4 and 5

Ths functon actvates the auto-lfter functon when the presser foot lftng devce (AK) s nstalled on the

sewng machne.

For the presser foot lifting device specifications, solenoid drive mode (+33 V) or air drive mode (+24 V)

can be selected.

The drve source voltage (CN3) s changed over between +33 V and + 24 V accordng to the drve

mode specification selection.

oFF

: Auto-lfter does not operate. (standard settng at the tme of delvery)

Auto-lfter does not operate. (standard settng at the tme of delvery)

(The presser foot does not automatcally go up when the program sewng s completed.)

on S

: Auto-lfter operates. (Solenod drve mode �+33 V�)

Auto-lfter operates. (Solenod drve mode �+33 V�)

on A

: Auto-lfter operates. (Ar drve mode �+24 V�)

Auto-lfter operates. (Ar drve mode �+24 V�)

■ Needle position changeover function for the time when the sewing machine stops (np) :

Switches 6 and 7

The needle poston at the tme when the sewng machne stops can be changed over.

: Lower stop poston (standard settng at the tme of delvery)

Lower stop poston (standard settng at the tme of delvery)

: Upper stop poston

Upper stop poston

3) Once you have completed the settng, press swtch 8 . The screen s changed over to the power swtch

OFF notification screen.

[Power switch OFF notification screen]

If "on" (auto-lifter operates) is selected without the auto-lifter installed, the machine startup is

momentarily delayed at the beginning of sewing. In addition, the one-touch type reverse feed

(touch-back) switch may be disabled. To avoid these troubles, be sure to select "off" (auto-lifter

does not operate) when the auto-lifter device is not installed.

) Keepng thread trmmng prohbtng swtch 1

held pressed, turn the power ON. Then, the

screen is changed over to the simplified func-

ton settng screen. The detals dsplayed on

the screen represent the current settngs.

2) Functon tems can be changed by pressng

swtches 2 and 3 , 4 and 5 or 6 and 7 .

4) Turn OFF the power swtch to ext from the