Table of Contents
Advertisement
[Step 1]
1) Confirm that step 1 is displayed on the panel. Now, set the number of stitches to 20 using switches 2 and 3 .
2) Set the feeding direction to the normal direction using switches 4 and 5 .
3) Set the stop state of the sewing machine to the needle-down stop mode using switches 6 and 7 .
If the number of stitches is set to 0 stitch or the stop-state of the sewing machine is set to the
automatic thread trimming mode
tion step.
4) Set the position of the presser foot, when the sewing machine stops, to the upper stop position using
switches 8 and 9 .
(If you want to specify, In particular, the length of time during which the presser foot Is raised, set It as
desired using switches !0 and !1 . In the Initial state, the length of time Is 60 seconds. Possible setting
range of the time during which the presser foot Is raised : 0.1 sec. to 99.9 sec.)
Settings done by switches
lifter can be used (i.e., FL ON).
[Step 2]
5) Press switch !2 once to display step 2.
6) Set the number of stitches to 10 using switches 2 and 3 .
2 4 6 8 !0
3 5 7 9 !1
, the machine will not proceed to the subsequent opera-
,
, !0 and !1 are only available under the setting where the auto-
8
9
!2 2
3
– 28 –
Advertisement
Table of Contents
