JUKI IT-100 Instruction Manual page 33

＜ Teaching mode ＞
In the teachng mode, t s possble to set the number of sttches of the step n a programmed sttchng pat-
tern to the number of sttches that has been actually sewn.
1
) In the programmed sttchng settng screen, press teachng swtch 1 to select the teachng mode.
2) The ndcaton shown on the number of sttches nput secton changes to
machne has entered the teachng mode.
3) Depress the front part of the pedal to make the sewng machne perform sewng untl the last sttch of the
current operaton step s reached.
The number of stitches is not counted for the stitch sewn by manually turning the sewing ma-
chine or using the needle up/down switch.
4) Return the pedal to ts neutral poston to make the sewng machne stop runnng. Now, the number of
sttches whch has been sewn s dsplayed.
5) Proceed to the subsequent step usng swtch 2 or make the sewng machne perform thread trmmng.
Ths completes the nput of the number of sttches for operaton step .
＜ One-shot automatic stitching ＞
The one-shot automatc sttchng functon can be separately set by steps.
) In the programmed sttchng pattern settng screen, press one-shot automatc sttchng swtch 1 to select
the one-shot automatc sttchng functon.
2) A mark s dsplayed on LCD secton of the swtch, whch shows the one-shot automatc sttchng functon
has been selected.
3) In the step where the one-shot automatc sttchng functon has been selected, the sewng machne
wll automatcally contnue sewng, once the sewng machne starts runnng, untl the end of the step s
reached.
2
1
– 30 –
. Ths shows that the sewng