Table of Contents
Advertisement
5) Press swtch 6 or 7 to check the parameter functons (Nos. to 3) and the parameter set values (ds-
played above swtch 9 ) related to the ancllary devce "AH0" (MF auto hemmer devce). The type of the
parameter functon and the parameter set value vary dependng on the ancllary devce to be selected.
) To change the parameter set value, press swtch 6 or 7 to dsplay the parameter functon and ts set
value you want to change. Press swtch 8 or 9 to change the parameter set value.
) After the completon of the changng procedure, press swtch !1 to return the screen to the prevous one.
When you press swtch !0 , the parameter set value s dscarded and s returned to the value before t s
changed.
■ Thread trimmer setting screen
) Fne adjustment of the thread trmmng acton can be carred out.
2) In the case of the thread trmmer of LU-5* seres, for example, the followng parameters can be adjusted.
: Instantaneous stop tme of thread trmmer
2: Thread trmmer OFF angle
3) Select the parameter you want to adjust wth swtch 1 or 2 . Change the set value of the parameter by
means of swtch 3 or 4 .
4) After the completon of the changng procedure, press swtch 6 to return the screen to the prevous one.
When you press swtch 5 , the parameter set value s dscarded and the parameter set value status s
returned to the state before t s changed.
!0
6
8
!1
7
9
1
3
5
2
4
6
3: Tenson release ON angle
– 4 –
Advertisement
Table of Contents
