Options; Ir Receiver 800; Hardwired Rcu - Barco R9002410 Owner's Manual

8

IR Receiver 800

This infrared receiver unit makes it possible to control the projector from another room.
There is a communication line with cable between the IR receiver and the projector or the RCVDS05.
information from the RCU can now be sent to this IR receiver.
The IR receiver 800
Order number : R9827515.

Hardwired RCU.

The control signals from the RCU can be sent to the projector via a wired connection.
Preparing your remote cable :
Use a shielded cable with a maximum length of 100 m and two mini-jack 3.5 mm connectors (order number : R313043).
- Peel back the vinyl covering of the cable on both sides and twist the wire core.
- Solder a jack plug as shown in drawing above to each end of the cable.
shield = ground
conductor = data information
When the cable is ready, plug one side in the remote control and the other side in the connector on the rear of the projector
labelled ‘remote’.
R5976101 BARCO CINE 5 ___________________________________________________________________________________

OPTIONS

displays the selected source on a 7-segment display.
shield
conductor
Options
The control
8-1