Ir Receiver 800 - Barco R9002328 Owner's Manual

This infrared receiver unit makes it possible to control the projector from another
room.
There is a communication line with cable between the IR receiver and the projector
or the RCVDS05. The control information from the RCU can now be sent to this
IR receiver.
The IR receiver 800 displays the selected source on a 7-segment display.
Order number : R9827515.
Screen
The control signals from the RCU can be sent to the projector via a wired
connection.
Preparing your remote cable :
Use a shielded cable with a maximum length of 100 m and two mini-jack 3.5 mm
connectors (order number : R313043).
- Peel back the vinyl covering of the cable on both sides and twist the wire core.
- Solder a jack plug as shown in drawing above to each end of the cable.
shield = ground
conductor = data information
When the cable is ready, plug one side in the remote control and the other side
in the connector on the rear of the projector labelled ‘remote’.
11-2
All manuals and user guides at all-guides.com
BARCOVISION 708
Projection room
shield
conductor
Communication cable
IR Remote Receiver 800
Control room
R5975059A BARCOVISION 708 200498