Table of Contents
Advertisement
6.
Please use the original power cord.
2.3
Preparing for installation
1.
We have applied to local operators (ISP, such as China Telecom, China Unicom, etc.)
for broadband services.
2.
Preparation of related devices:
1)
Modem (This item is not required when connected directly to Ethernet).
2)
Hub or switch or wireless devices.
3)
The PC with Ethernet card and Internet Protocol (TCP/IP) installed.
4)
Power socket.
3.
Preparation of tools and cables: Network cables.
2.4
Hardware Installation
Before installing the device, make sure the broadband service is normal. If you cannot
access, please contact operators (ISP) to resolve the problem. After successfully
accessing to the network, follow these steps to install the device. The power plug must be
removed during installation.
Place the device on a stable work bench:
1.
Place the device on a sufficiently large, stable and properly-grounded work bench with
its bottom up.
2.
Remove the adhesive protective paper from the foot pad, and stick the 4 pads in the 4
round slots at the bottom of the casing respectively.
3.
Flip over the device, and place it on the workbench stably.
http://www.level1.com
Chapter 2 Hardware Installation
Page 11
Advertisement
Table of Contents
