Table of Contents
Advertisement
5.3
Interface Traffic
This section describes the Start-> Interface Traffic page, as shown in Figure 5-2. You
can view the average, maximum, sum and the current real-time rate for the relevant ports
to receive and send data, and provide different units (Kbit/s and KB/s) for them.
Tip:
If this page fails to display properly, please click the hyperlink "If it cannot display properly,
please install a svgviewer" to have the svgviewer plug-in installed.
WAN1: WAN port of the device, click on the tab to view the dynamic figure of
receiving, sending traffic.
APClient: The wireless client of the device, click on the tab to view the dynamic figure
of receiving, sending traffic.
LAN: LAN port of the device, click on the tab to view the dynamic figure of receiving,
sending traffic.
Timeline: The x-coordinate in the flow chart. You can click on the timeline options (1x,
2x, 4x, 6x in the figure) in the figure to determine the display effect.
Flowline: The y-coordinate in the flow chart. You can choose the display effects as
needed (standardization, maximization as shown in the figure).
http://www.level1.com
Figure 5-2 Interface Traffic
Chapter 5 Start Menu
Page 21
Advertisement
Table of Contents
