Table of Contents
Advertisement
9.3.7 Instance of PPPoE server configuration
1.
Demand: Only the users authenticated by the Intranet can access the Internet.
Now, 3 accounts are configured for intranet users, and their user names are test1, test2, and test3
respectively. Initial passwords are: password1, password2, password3, in which test1, test2 are
separately bound with 10.0.0.1, 10.0.0.2 and the charging feature is enabled (the using period of
the account is from October 1, 2012 to December 31, 2013) and a notification is issued 15 days
prior to account expiration; the maximum number of sessions of test3 is set to 5.
2.
Configuration steps:
1)
Configure the PPPoE server. Log on to the device, enter the User management ->PPPoE
server page, configure the content as shown in the figure below, and enable the forced PPPoE
authentication and allow users to modify the dial-up password (The password change
message can be given to users by configuring the routine business notification feature).
2)
Configuration of PPPoE account. Enter the PPPoE account Settings. Click on the <Add
new entry>, configure a PPPoE account, bind the account with the IP address, and enable the
charging feature. The configured content with the user name of test1 is as shown in the figure
below:
http://www.level1.com
Figure 9_16 Instance - PPPoE Global Settings
Chapter 9 Wireless configuration
Page 97
Advertisement
Table of Contents
