Table of Contents
Advertisement
2.
A VLAN can contain more than one port, and one port can belong to more than one VLAN.
5. Instances of Port VLAN
Requirements: The host under the LAN1 port can communicate with the hosts under the LAN2,
LAN3 ports, but those under the LAN2 and LAN3 ports cannot access to each other.
Configuration steps:
1.
Modify VLAN 1, whose member ports only include: 1, 2.
2.
Create VLAN 2, whose member ports are: 1, 3.
Analysis: Both LAN1 port and LAN2 port belong to VLAN1, both LAN1 and LAN3 belong to
VLAN2; the hosts under the fixed LAN1 port can communicate with the hosts under LAN2,
LAN3 ports. Additionally, both LAN2 port and LAN3 port are not in the same VLAN, and the
hosts under LAN2 and LAN3 cannot access to each other.
8.7
SYSLOG configuration
This section describes the Advanced Configuration -> SYSLOG configuration page.
Enable Syslog service: After the syslog service feature is enabled, this feature will send a
large amount of information of device operation to a syslog server, which makes it easy for
administrators to analyze system conditions, and monitoring system activity.
Address of syslog server (domain name): Sets the address of the syslog server, which can be
an IP address or a domain name.
Port of Syslog server: Sets the service ports that are opened by the syslog server, whose
default value is 514.
Syslog message type: Sets the type of syslog message to be sent, whose default value is
Local0.
http://www.level1.com
Figure 8_18 SYSLOG configuration
Chapter 8 Wireless configuration
Page 80
Advertisement
Table of Contents
