Table of Contents
Advertisement
The WPS feature is temporarily not supported by this software version, so the
Note
corresponding status LED is not used.
2.
Description of interfaces
Interface
Integrated with multiple Ethernet (100M) ports, LAN port is an RJ-45, and
LAN
supports adaptive positive and negative lines.
WAN
WAN port is an RJ-45 and supports adaptive positive and negative lines.
USB
3G Internet card interfaces.
Antenna
For transmitting and receiving wireless data.
3.
Reset button
Reset button can be used to recover the device's factory settings when you forget the
administrator password. Method: In the process of charged operation, hold down the
Reset button for more than 5 seconds, and then release the button. The device will be
returned to its factory settings after operation, and automatically restart.
Note: The above operations will delete all the original device configurations; please
use it with care!
2.2
Precaution for installation
1.
Make sure to install the workbench stably.
2.
Do not place any heavy objects upon the device.
3.
Make sure that the device is stored in a dry and ventilated area with proper heat
dissipation, and do not put it in a dirty and damp place.
4.
Avoid exposing the device directly to the sunlight and keep it far away from heating
elements.
5.
Mount the device away from the places where high power radio transmitters, radar
transmitters reside as far as possible.
http://www.level1.com
LED that corresponds to the port stays lit, and it will
flash if there is flow.
Table 2-1 LED description
Notes
Table 2-2 Description of interfaces
Chapter 2 Hardware Installation
Page 10
Advertisement
Table of Contents
