Table of Contents
Advertisement
Chapter 4.
By reading this chapter, you can understand the basic network parameters required for
the device to access to the Internet, and these parameters are configured to connect the
device to the Internet. Before configuring "Internet Line" in the Configuration Wizard, you
should properly configure the network settings of the network computer. For specific
methods, see Chapter 3 Logging in the Device.
If this is the first time for you to log in the device, a configuration wizard homepage
appears directly in the main operating page. As shown in Figure 4-1:
In logging next time, the wizard will no longer automatically pop up: When checking it,
you can go directly to the System Status page in logging next time.
Exit the wizard: Exits the Configuration Wizard and returns to the System Status
page.
Next step: Enter the Selection of device access mode page
4.1
Configuration of WAN1 port
Access modes provided by WAN1 port include: dynamic IP access, fixed IP access,
PPPoE access.
http://www.level1.com
Configuration Wizard
Figure 4-1 Homepage of configuration wizard
Chapter 4 Configuration Wizard
.
Page 17
Advertisement
Table of Contents
