Identity Binding - LevelOne WGR-2301 User Manual

Interface: Selects access modes (WLAN, 3G, APClient)

WAN1 configuration: Configure WAN1 to provide access to intranet users.

3G client configuration: The device provides access to intranet users as a 3G
client.

Wireless client configuration: The device provides access to intranet users as a
wireless client.
Detection interval: The time interval for sending inspection packets, Unit: seconds,
when you enable line detection, the value range is 1~60 (the value is 0, which means
not to enable the line detection).
Detection times: The number of inspection packets sent within the detection cycle
(one detection packet is sent per time), which is 10 times by default.
Detection target: The destination address to be detected, which is the gateway IP
address by default; if the gateway disallows PING, select a different IP address as the
destination IP address of the PING detection.
Bandwidth: Sets the bandwidth that ISP provides to the current line.
Save: The above configuration parameters take effect.
Refill: Restores to the configuration parameters before modification.
Return: Returns to the line combination state information page.

6.2.5 Identity binding

When the device has multiple WAN ports, you can enter the Network parameters -> Line
http://www.level1.com
Figure 6-11 Line combination configuration
Chapter 6 Network parameters
Page 33