Table of Contents
Advertisement
Chapter 3.
This chapter describes how to configure the correct network settings for the network
computers, how to log on to the appliances and how to use shortcut icons to quickly link to
the HiPER website for product information and services.
3.1
Configuring the correct network settings
Before logging to the device through the WEB interface, you must correctly configure the
network computers in network settings.
First, connect your computer to the LAN port of the device, and then set the computer's IP
address.
The first step is to set the computer's TCP/IP. If it has been set correctly, skip this step.
The second step is to set the computer's IP address. You can use either of the following
methods:
1.
Set the computer's IP address as one of the addresses from 192.168.1.2 -
192.168.1.254, the subnet mask is 255.255.255.0, and the default gateway is
192.168.1.1 (the LAN IP address of the device), and the DNS server is the address
provided by the local operator.
2.
Set the computer's TCP/IP as "Obtain an IP address automatically". After setting, the
built-in DHCP server of the device will automatically assign IP addresses to
computers.
The third step is to use the Ping command on your computer to check whether it is
connected to the device. In Start ->Operation, type in cmd, and click <OK> to open the
command window. Type in ping 192.168.1.1.
The following lists two kinds of results of executing the Ping command in the Windows XP
environment:
If the screen is shown as follows, it indicates that the computer has been successfully and
a connection is established on the device.
http://www.level1.com
Logging to the device
Chapter 3 Logging Device
Page 13
Advertisement
Table of Contents
