Chapter 7 Wireless configuration
Device A, and access to the Internet through Device A.
2. Analysis: Achieved by the following solutions
Solution I: Devices A and B are set to Repeater Mode.
Solution II: Devices A and B are set to Bridge Mode.
Solution III: Devices A and B are set to Repeater Mode, Bridge Mode respectively.
Solution IV: Devices A and B are set to Repeater Mode, Lazy Mode respectively.
Solution V: Devices A and B are set to Bridge Mode, Lazy Mode respectively.
Solution VI: Device A is set to AP Mode while Device B is set to AP Client Mode.
3. Configuration steps:
Solution I: Both are Repeater Mode
1)
Configure the AP working mode of Device A as Repeater Mode, and the configuration
content is shown in the figure below:
http://www.level1.com
Page 53