Table of Contents
Advertisement
protocol is ICMP, the port range needs not be configured.
Effective time setting: Selects the time period for the policy routing takes effect, and the
default date is "Every day". The time is "All day". You can go to Advanced settings —>
Configure policy route page to edit the time for the policy route to take effect.
Tip:
1. When all the packets match the defined source IP address, protocol and destination port,
they will be forwarded to the specified interface, but the packets that cannot find a
matching policy routes will go the normal route.
2. The execution order of policy routing: Static route to the LAN port > Policy routing >
Static route to the WAN port.
8.4
Anti-NetSniper
This section describes the Advanced Configuration -> Anti-NetSniper page and configuration
methods. Network vanguard defense is used to crack the shared detection set by the network
operator. Verify that the intranet is experiencing a sharing problem, or don't enable that function.
8.5
Port mirroring
This section describes the port mirroring function of the Advanced configuration -> Port
mirroring page. With the port mirroring function, you can copy the flow of the monitoring port to
the monitoring port, to provide the detailed information on the transmitting status of the monitored
ports, allowing network managers to make traffic monitoring, performance analysis and
troubleshooting.
TM
Except HiPER
840G, the devices of HiPER series that support the port mirroring function have
the default LAN1 port of monitoring port, and other LAN ports are monitored ports. The
http://www.level1.com
Figure 8_14 Anti-NetSniper
Chapter 8 Wireless configuration
Page 77
Advertisement
Table of Contents
