Table of Contents
Advertisement
subject to one-to-one mapping.
External starting IP address: In the NAT rule, the external starting IP address mapped to the
internal starting IP address.
Tip:
1.
Each One2One rule can only bind 20 external addresses at maximum.
2.
"External starting IP address" must be set, and the actually mapped external IP address is
gradually increased from the set value. For example, if "Internal starting IP address" is set to
192.168.1.50; "Internal ending IP address" is set to 192.168.1.52; "external starting address"
is set to 200.200.202.50, then 192.168.1.50, 192.168.1.51, 192.168.1.52 are in turn mapped
to 200.200.202.50, 200.200.202.51, 200.200.202.52.
8.1.4 DMZ
The DMZ functions of the device are described below.
Enable DMZ function: Enables or disable the DMZ function.
DMZ host IP address: The IP address of the network computer used as a virtual server (DMZ
host).
Tip:
The computer that is set to a DMZ host will lose the firewall protection of the device, which takes
effect to all WAN ports.
http://www.level1.com
Figure 8_6 DMZ configuration
Chapter 8 Wireless configuration
Page 69
Advertisement
Table of Contents
