Ap Mode - LevelOne WGR-2301 User Manual

7.1.1 AP Mode

Enable wireless function: Only after the wireless function is enabled can the wireless
clients be connected to the device, to have wireless communications through the
device, connect and access the cable network to which the device is connected.
AP working mode: The AP Mode is selected here, namely the pure AP mode, in which
the peer device can be an AP Client mode and single client.
SSID: SSID (Service Set Identification) is used to uniquely identify a string of wireless
network, and is case sensitive.
Wireless mode: This parameter is used to set the modes of a wireless device,
providing three options: only 11g, only 11n, and 11b/g/n hybrid.

Only 11g: pure 802.11g mode, in which the maximum rate is up to 54M bps. The
wireless sites compatible with the IEEE 802.11g standard can be connected to
the device.

Only 11n: Pure 802.11n mode, in which the maximum rate is up to 150M bps.
The wireless sites compatible with the IEEE 802.11n standard can be connected
to the device.

11b/g/n hybrid: The wireless sites in compliance with IEEE 802.11b, 802.11g or
802.11n standard will be connected according to their modes, with the maximum
rates of 11M bps, 54M bps and 150M bps respectively.
http://www.level1.com
Figure 7-1 AP Mode
Chapter 7 Wireless configuration
Page 46