Maintenance; Cleaning The Brazier And Brazier Housing - Piazzetta IP 78/68 Instructions For Installation, Use And Maintenance Manual

7.0 MAINTENANCE

Pursuant to current regulations on the safety of electrical equipment, you must contact a Piazzetta Group After-Sales Service Centre or a qualified
electrician for all and any work connected with installation, maintenance or servicing that involves access inside the cladding or the smoke chamber.
Routine maintenance is to be considered compulsory for correct and efficient stove operation. If maintenance is not carried out with the recommended
frequency, stove performance could suffer. The manufacturer will not be responsible for stove deterioration or malfunction if due to poor maintenance.
All maintenance work (cleaning, any replacements, etc.) must be carried out when the stove is shutdown, completely cold and the supply cable
disconnected.
The frequencies given in each of the sections below should be considered as a rough guide.
To dispose of the ashes, see "DISPOSAL OF ASHES".
Do not use materials that could scratch or damage the glass, as scratches could become cracks or fractures; under no circumstances use abrasive
substances.
a
The frequency of cleaning depends on how much the stove is used and the quality of the fuel.

7.1 CLEANING ThE bRAzIER ANd bRAzIER hOUSING

Clean the brazier area daily and before every start-up:
- remove the brazier deflector (if there is one);
- release the brazier from its housing;
- remove all ash and any incrustations which may have formed, paying
attention to clear the air passages using an appropriate tool;
- keep the "start-up hole" at the side of the brazier clean;
- check the brazier housing and remove any ash present.
a
When repositioning and before starting up the appliance,
check that the brazier is positioned correctly in its housing
and pushed in the direction of the side where the start-up
hole is located.
a
A vacuum cleaner is needed when carrying out this cleaning
operation to vacuum up the ash.
Fig. 63
Fig. 64
Fig. 65
Fig. 66
H07028420 / DT2000990 – 01
DT2012365-00
DT2010057-02
DT2012366-00
DT2033376-00
DT2033377-01
DT2033979-01
DT2030239-02
57