Lighting For The First Time - Piazzetta IP 78/68 Instructions For Installation, Use And Maintenance Manual

6.3 LIGhTING FOR ThE FIRST TIME

• Before lighting the stove for the first time, check that the grate is properly placed.
• There will be odours when lighting the first few times due to the evaporation of paints and oils used during the manufacturing process.
During this stage, air the room well where the stove is installed and avoid staying there any length of time since the fumes being given off could be
harmful to persons or pets.
The stove body should have settled down and the paints fully evaporated after having lit the stove a few times.
To this end, follow the instructions given below when using the stove:
- Operate at medium power for the first 5-6 hours after igniting the fuel (the expansion caused by the heat during this stage will allow the stove
body to settle).
- After the settling-down stage the stove must be set to operate at maximum power for a period between 6 and 10 hours, depending on the amount
of paint on the stove body that must be evaporated off.
The time indicated for operation at maximum power does not necessarily have to be continuous, but may be divided up into two periods separated
by an interval of at least 3-4 hours with the stove shut down.
At the end of the recommended period the paint will have evaporated and the stove should be used at the suitable power for normal use.
If necessary the stove may be used for a further period at maximum power to ensure complete and final disappearance of all paint residue.
When the hopper is being loaded for the first time the loading auger needs time to fill up; during this stage the pellets are not distributed inside the
firebox and it is highly probable that the first attempt at ignition fails. In this case we purpose to provide to load manually the auger screw following
the instructions of the table "LOADING AUGER" in the "PARAMETER MENU".
If the alarm is activated, shut down the stove by pressing the ON/OFF key for a few moments, remove the fuel in the grate and then set the stove
for a new ignition process.
Dispose the not burned pellets contained in the brazier.
32
H07028420 / DT2000990 – 01
DT2010082-07