Cleaning The Glass (Daily); Replacing The Window; Replacing The Remote Control Batteries - Piazzetta IP 78/68 Instructions For Installation, Use And Maintenance Manual

7.5 CLEANING ThE GLASS (dAILy)

a
The glass should be cleaned when cold using ammonia-based degreasing agents and not corrosive substances such as solvents.
Although it is likely that tar will build up on the glass during the lighting stage, it will burn off with the stove in full operation. If, however, the tar is left
to build up over a long period it will require more effort to remove. We therefore recommend that the glass be cleaned daily before lighting the stove.
d
Do not use any material that could scratch or spoil the glass, as scratches may develop into cracks or breaks.

7.6 REPLACING ThE wINdOw

The stove is fitted with a 4 mm thick glass panel, resistant to thermal shock up to 750°C; the glass can only be broken by heavy impact or misuse.
Do not slam the door or hit the window.
In case of breakage replace only with a Gruppo Piazzetta spare part.
To replace, proceed as follows:
- wear protective gloves;
- remove the door and lie it flat;
- loosen the screws visible on the inside of the door;
- remove the frame and glass carefully;
- if the fibreglass seal and glazing bead have deteriorated, replace them;
- change the glass panel then replace the frame, tightening the screws carefully but not excessively;
- remount the door.
If other problems occur, consult your nearest retailer.

7.7 REPLACING ThE REMOTE CONTROL bATTERIES

Slide the cover off the back of the remote control and replace the batteries
with new ones ensuring that the (+) and (–) directions are correct.
The batteries must be of the type AAA (LR03) 1.5V.
a
Rechargeable batteries are unsuitable for the remote control as
they do not guarantee sufficient voltage for correct operation.
Replace the back cover on the remote control.
The writing shown to the side appears on the display of the remote control.
A feedback procedure between the remote control and the receiver starts
automatically.
After a few seconds the initial display returns.
In other words, stove status prior to changing the batteries will be
displayed.
E.g.: if the stove was shut down, the display will appear as shown to the
side.
The new batteries must be of the same type as above; failure to comply
with these instructions could cause a risk of explosion.
The old batteries must be disposed of properly in compliance with
the applicable laws in force.
Fig. 70
H07028420 / DT2000990 – 01
T E S T H W 4
I N I Z I A L E
V E R 4
O F F
0 9 : 5 3 2 0
°C
1
DT2010062-05
DT2010093-06
DT2010218-04
DT2010218-00
59