Multitech MULTIMODEM MT5600ZDX Owner's Manual page 36

MT5600ZDX Owner's Manual
Command: W n
Values:
Default:
Description: W0
W1
W2
*This command controls the format of CONNECT messages. The parame-
ter value, if valid, is written to S31 bits 2 and 3. The Wn command can be
overridden by register S95.
Command: X n
Values:
Default:
Description: X0
X1
X2
X3
X4
* If the modem is in facsimile mode (e.g., +FCLASS=1), the only message
sent to indicate a connection is CONNECT without a speed indication.
Command: Y n
Values:
Default:
Description: Y0
Y1
36
Connect Message Control
n = 0, 1 or 2
0
Upon connection, the modem reports DTE speed only
(e.g., CONNECT 56000). Other responses are dis-
abled.
Upon connection, the modem reports the line speed, the
error correction protocol, and the DTE speed. Other
responses are disabled.
Upon connection, the modem reports DCE speed only
(e.g., CONNECT 28800). Other responses are dis-
abled.
Result Code Selection
n = 0–4
4
Sends OK, CONNECT, RING, NO CARRIER, ERROR
and NO ANSWER ); does not look for dial tone or busy
signal.
Sends X0 messages and CONNECT speed.
Sends X1 messages with NO DIALTONE .
Sends X1 messages with BUSY .
Sends all responses.
Long Space Disconnect
n = 0 or 1
0
Disable sending or responding to long space break
signal on disconnect.
Enables long space disconnect. In non-error correction
mode, the modem will send a long space of four sec-
onds prior to going on-hook. In non-error correction
mode, the modem will respond to the receipt of a long
space (i.e., a break signal greater than 1.6 seconds) by
going on-hook.