Multitech MULTIMODEM MT5600ZDX Owner's Manual page 57

Register Unit
S30
1 minute 0–255
S31 Bit-Mapped Options Status (Indicates the status of command Op-
tions.) Default: 194
Bit 0
Bit 1
Bit 2-3
Bit 4-5
Bit 6-7
S32 decimal
S33 decimal
Chapter 3 - AT Commands, S-Registers and Result Codes
Range Default
0
Single Line Connect Message Enable/Disable (\Vn)
0 =Messages controlled by S95, Wn and Vn (\V0)--
Default
1 =Single Line Connect Message (\V1)
Auto Line Speed Detection (Nn)
0 = Disabled (N0)
0 = Enabled (N1)--Default
Error Correction Progress Messages (Wn)
0 = DTE speed only (W0)--Default
1 = Full Reporting (W1)
2 = DCE speed only (W2)
Caller ID (#CID)
0 = Caller ID Disabled (#CID = 0)--Default
1 = Short Formatted Caller ID Enabled
2 = Long unformatted Caller ID Enabled
0–255 17
0–255 19
Description
S30 specifies the length of time (in
tens of seconds) that the modem
waits before disconnecting when no
data is sent or received. This func-
tion is only applicable to buffer mode.
(#CID = 1)
(#CID = 2)
Reserved
Sets the value of the XON character.
Sets the value of the XOFF character.
57