Result Codes - Multitech MULTIMODEM MT5600ZDX Owner's Manual

MT5600ZDX Owner's Manual

Result Codes

When the MultiModemZDX receives an AT command from the terminal
or PC, the MultiModemZDX tries to execute the command, then sends
a status message to the PC or terminal which reports the "results" of
the command (hence the name "result codes"). The MultiModemZDX
Command mode provides you with several responses, or "Result
Codes" , that provide visual responses during Command mode
operation. These Result Codes are displayed on your PC's video
monitor.
Terse Verbose
0 OK
1 CONNECT
2 RING
3 NO CARRIER
4 ERROR
5 * CONNECT 1200
6 NO DIALTONE
7 BUSY
8 NO ANSWER
10 * CONNECT 2400
11 * CONNECT 4800
12 * CONNECT 9600
13 * CONNECT 7200
14 * CONNECT 12000
15 * CONNECT 14400
16 * CONNECT 19200
17 * CONNECT 38400
18 * CONNECT 57600
19 * CONNECT 115200
22 * CONNECT 75TX/1200RX Connected at V.23 Originate
23 * CONNECT 1200TX/75RX Connected at V.23 Answer
24 * DELAYED
32 * BLACKLISTED
33 FAX
35 DATA
40 * CARRIER 300
64
Table 3-4 Result Codes
Description
Command executed
Modem connected to line
Ring signal detected
Carrier signal lost or not
detected
Invalid command
Connected at 1200 bps
No dial tone detected
Busy signal detected
No answer at remote end
Connected at 2400 bps
Connected at 4800 bps
Connected at 9600 bps
Connected at 7200 bps
Connected at 12000 bps
Connected at 14400 bps
Connected at 19200 bps
Connected at 38400 bps
Connected at 57600 bps
Connected at115200 bps
Delay is in effect for the dialed
number
Dialed number is blacklisted
Connected FAX mode
Connected DATA mode
0-300 bps Data Carrier Detected