Multitech MULTIMODEM MT5600ZDX Owner's Manual page 13

To install your MT5600ZDX:
1. Attach MT5600ZDX to dial-up phone lines using the RJ11
telephone cord. This is accomplished by plugging one end of the
cable provided with the MT5600ZDX into the telephone jack in
your home or office; and plugging the other end into the LINE jack
on the MT5600ZDX.
Note: The LINE jack is not interchangeable with the PHONE jack
on the MT5600ZDX. Do not plug the telephone into the LINE jack
or the line cable into the PHONE jack.
2. Attach your MT5600ZDX to your PC or terminal with an RS232 (or
V.24) cable (see Figure 2-1). Be sure to tighten the mounting
screws on the DB connectors.
3. Connect your telephone set to phone jack via RJ11 cable.
4. Attach your MT5600ZDX to the AC Power transformer and
plugging the AC connector into a live AC outlet.
5. Turn on power by flipping the "ON/OFF" switch on the side of the
MT5600ZDX to the "ON" position.
Note: Use only the power supply provided with the MT5600ZDX.
Use of any other power supply will void the warranty and could
damage the modem.
6. Make sure modem and computer/terminal serial port baud rates
are adjusted. (Note that several programs can check this for you.
If you have MS-DOS 5.0 or higher, a program called MSD.EXE
[Microsoft Diagnostics] is in your DOS directory. Typing MSD at
the DOS prompt brings up a screen that provides a variety of
information about your computer. Select COM ports and it lists
information about your com port, e.g., UART Type, Address, and
IRQ, to name a few. Once you know your serial port's UART type,
you can set your communications's software appropriately.)
7. Proceed to Chapter 3 of this manual, or to your data
communications software manual.
Chapter 2 - Installation
13