Multitech MULTIMODEM MT5600ZDX Owner's Manual page 38

MT5600ZDX Owner's Manual
Command: &J n
Values:
Default:
Description: &J0
&J1
*This command is only included for compatibility and performs no function
except to load the S-Register. The parameter value, if valid, is written S21 bit
1.
Command: &K n
Values:
Defaults:
Description: &K0
&K3
&K4
&K5
&K6
Command: &L n
Values:
Defaults:
Description: &L0
*This command requests leased line or dial-up operation. This command is
provided for compatibility only; no mode change is performed, dial-up opera-
tion continues. The OK response is returned for a valid parameter, but no
other action is performed. The parameter value, if valid, is written to S27 bit
2.
Command: &M n
Values:
Defaults:
Description: &M0
&M1
*&M0 selects direct asynchronous operation. Note that the command
sequence &M0\N0 selects normal buffered mode, but the command sequence
\N0&M0 selects direct mode. This is because the \N0 command is analogous
to the &Q6 command.
38
Telephone Jack Control
n = 0 or 1
None
NA
NA
Flow Control Selection
n = 0, 3, 4, 5 or 6
3
Flow control disabled.
Enable CTS/RTS hardware flow control.
Enable XON/XOFF flow control.
Enable transparent XON/XOFF flow control.
Enable both RTS/CTS and XON/XOFF flow control.
(Default for fax and voice modes.)
Leased Line Operation
n = 0
None
NA
Communications Mode
n = 0
0
Asynchronous mode.
Reserved—responds ERROR.