Multitech MULTIMODEM MT5600ZDX Owner's Manual page 34

MT5600ZDX Owner's Manual
Command: L n
Values:
Default:
Description: L0
L1
L2
L3
Command: M n
Values:
Default:
Description: M0
M1
M2
M3
Command: N n
Values:
Default:
Description: N0
N1
Command: O n
Values:
Default:
Description: O0
O1
Command: Q n
Values:
Default:
Description: Q0
Q1
34
Monitor Speaker Volume
n = 0, 1, 2, or 3
1
Select low volume.
Select low volume.
Select medium volume.
Select high volume.
Monitor Speaker Mode
n = 0, 1, 2, or 3
1
Speaker always off.
Speaker on until carrier signal detected.
Speaker always on when modem is off-hook.
Speaker on until carrier is detected, except while dial-
ing.
Modulation Handshake
n = 0 or 1
1
Disables auto-mode (automatic modulation negotia-
tion); uses connection speed specified in S37. (Equiv-
alent to +MS <automode> subparameter to 0.)
Enables auto-mode. (Equivalent to +MS <automode>
subparameter to 1.)
Return Online to Data Mode
0 or 1
None
Enters on-line data mode without a retrain. Handling is
determined by the Call Establishment task. Typically, if
a connection is established, this command connects the
DTE back to the remote modem after an escape (+++).
Issue a retrain and return to online data mode.
Enable/Disable Result Codes
n = 0 or 1
0
Enable Result Codes.
Disable Result Codes.