Multitech MULTIMODEM MT5600ZDX Owner's Manual page 41

Command: &V1
Values:
Description:
TERMINATION REASON...... LINK DISCONNECT or
Last TX Data Rate
Highest TX Data Rate
Last RX Data Rate
Highest RX Data Rate
Error Correction Protocol ... LAPM
Data Compression
Line Quality
Highest SPX RX state ......
Highest SPX TX state ......
Command: &W n Store Current Configuration
Values:
Default:
Description: &W0
&W1
Command: &Y n
Values:
Default:
Description: &Y0
&Y1
Command: &Z n = x Store Telephone Number
Values:
Default:
Description:
Chapter 3 - AT Commands, S-Registers and Result Codes
Display Last Connection Statistics
n/a
Displays the last connection statistics in the following
format (shown with typical results):
n = 0 or 1
None
Store active modem settings in NVRAM as profile 0.
Store active modem settings in NVRAM as profile 1.
Select Stored Configuration for Hard Reset
n = 0 or 1
none
Select stored configuration 0 on power-up.
Select stored configuration 1 on power-up.
n = 0, 1, 2, or 3 memory locations
x = Dialing string
None
Stores telephone dial string x in memory location n .
Dial the stored number using the command ATDS=n .
LOCAL REQUEST
...... 33600 BPS
...... 33600 BPS
...... 28800 BPS
...... 28800 BPS
..... V42Bis
...... 030
068
067
41