Cylinder Cover Gasket Components; Replacement - Geely FC Workshop Manual

Cylinder cover gasket components

Replacement

1. Take measures to prevent gasoline leaking.
2. Remove timing chain assembly.
3. Remove camshaft.
As sequences shown in the diagram, evenly loosen at
several times, and remove 19 bearing cover bolts, and then
remove 9 bearing covers of intake camshaft and exhaust
camshaft.
4. Remove cylinder head assembly.
(a) Remove warm air water outlet pipe from cylinder head.
(b) As shown in the diagram, evenly loosen 10 cylinder head
bolts with 10mm dual hexagonal sleeves at several times,
and then remove 10 cylinder head bolts and plain washer.
Notes:
Be careful not to let washer fall into cylinder head.
Incorrect disassembling sequence will cause cylin-
der head warp or chap.
5. Remove cylinder head gasket components
[4G18-1003160].
6. Install cylinder head gasket components.
Put new cylinder head gasket on the cylinder body.
Notes:
Pay attention to installation direction.
Gently put down cylinder head to avoid damaging
cylinder head gasket.
7. Install cylinder head assembly.
Hint: Lock up cylinder head bolts as 2 steps.
(a) Coat a thin layer of engine oil at bolt thread and the bottom
of bolt head.
(b) As shown in the diagram, evenly tighten 10 cylinder head
bolts and plain washer with 10mm dual hexagonal sleeves
at several times.
Torque:
Engine mechanism - Cylinder cover gasket components
63