Overhaul - Geely FC Workshop Manual

Overhaul

Hint:
When assembling, please work by the sequence opposite with disassembling sequence, but
when it has items that need to pay special attention, it will add special specification.
This overhaul procedure is the disassembling procedure for left side, and the procedure for
right side is same.
1. Disassemble driver chair assembly [68010061]
(a) Disassemble fixing clamp.
(b) Use screw driver to disassemble left lower trim board of driver
chair [68010062].
Hint: before using screw driver, it is necessary to wrap
its needled top with adhesive tape.
(c) Use screw driver to disassemble right rear lower trim board
of driver chair [68010065].
Hint: before using screw driver, it is necessary to wrap
its needled top with adhesive tape.
(d) Use screw driver to disassemble right front lower trim board
of driver chair [68010064].
Hint: before using screw driver, it is necessary to wrap
its needled top with adhesive tape.
(e) Disassemble the joint.
(f) Disassemble four bolts and front chair.
Note: Do not damage automobile body.
2. Disassemble front chair pillow assembly [68010066]
3. Disassemble chair vertical adjusting button
Disassemble fixing clamp and chair vertical adjusting
button.
4. Disassemble declining adjustment releasing handle.
Use screw driver to disassemble declining adjustment releas-
ing handle.
Hint: before using screw driver, it is necessary to wrap its
needled top with adhesive tape.
Chair--Front chair
349