Geely FC Workshop Manual page 277

(3) Fix the module on wheel.
a. Assemble two bolts with gasket on two assembling holes
of safety airbag module at the side of driver.
Size of bolt:
Note: tighten the bolts with hand until they could
not be turned in. But they could not be
screwed too tightly.
b. Use maintenance electric wire used for automobile to
fix safety airbag module at the side of driver on wheel.
Section area of nude wire part of wiring harness is more
than 2 mm 2 . If the wiring harness is too thin, it might
break for the shake when airbag explodes. This is very
dangerous.
c. Use three wiring harnesses, and the wiring harness
should twist the bolts at the two sides of airbag assem-
bly twice at least. Tighten the wiring harness twisted on
fixed bolts to avoid them loosen, if wiring harness loosen,
they might incur airbag assemble loosens for shake
when airbag explodes. This is very dangerous.
d. Place the airbag module upwards, and bind the con-
necting bolts at the two sides of airbag module in wheel
hub bolt holes of wheel. Adjust the fixed position of airbag
module to make the joint hang in the wheel hub hole of
wheel. Wiring harness should be tightened. The metal
surface of airbag assembly must face the downside to
prevent wiring harness from breaking for airbag
explosion, explosive force will throw airbag to air to hurt
human or surrounding things. Airbag explosion will leave
track for surrounding things, so used wheel should be
scraped.
(4) Place wheel on flat ground, and connect the one end of
wiring harness used for unfolding with airbag short wiring
harness, and connect the other end with short circuit.
266
Supplemental restraint system--Scrap treatment for safety airbag
L 35.0 mm
M 6.0 mm
Safety airbag assembly
Wiring harness for explosion