Steering Column System; Overhaul - Geely FC Workshop Manual

Steering column system

Overhaul

1. Put the front wheels towards the front.
2. Disassemble safety airbag assembly at the side of
driver (equipping with SRS) [67000179]
Note: if disconnecting airbag joint when ignition switch
locates at ON position, checking number will record it.
(a) Put the front wheels towards the front.
(b) Use planetary sleeve wrench to loosen two planetary
screws until the concave slot around the screw contacts
the screw shell.
(c) Pull out airbag assemble from steering wheel, and
disassemble airbag joint.
(d) Disassemble the terminal.
Warning:
When storing safety airbag assembly at the side
¡ñ ¡ñ
¡ñ
¡ñ ¡ñ
of driver, it is necessary to put the surface of
airbag assembly towards the upside.
Do not disassemble airbag assembly.
¡ñ ¡ñ
¡ñ
¡ñ ¡ñ
Note: when disassembling airbag assembly, pay
attention not to pull airbag wiring harness.
3. Disassemble steering wheel assembly [67100001]
(a) Disassemble the fixed screw cap of steering wheel.
(b) Make corresponding marks on steering wheel and main
shaft assembly.
(c) Use special tool to disassemble steering wheel.
4. Disassemble upper/lower decoration plate of
steering column [64000128/64000129]
5. Disassemble left combination switch assembly
[67000078] (referring to page 298)
194
Steering column--Steering system Steering column--Steering system
Steering column--Steering system
Steering column--Steering system Steering column--Steering system
screw shell
airbag joint
Wrong
Correct
Align the mark
planetary
screws