Tire and wheel
Wheel and tire system
Inspection
1. Check tire.
(a) Check tire is worn and inflation pressure is proper.
Cold tire inflation pressure:
Tire size
*1 It is used under the condition of speed below 160 km/h.
(b) Check tire run-out with dial indicator.
Tire run-out:
2. Adjust tire position.
Hint: see adjusting position of tire shown in the dia-
gram whether there is spare tire or not.
3. Check wheel balance.
(a) Check and adjust with off-the-car balancing machine.
(b) Check and adjust with in-the-car balancing machine if
necessary.
Unbalanced mass after adjusting:
4. Check axial clearance of front wheel bearing
(see Page 123).
5. Check end surface run-out of front wheel shaft hub
(see Page 123).
6. Check axial clearance of rear wheel bearing
(see Page 129).
7. Check end surface run-out of rear wheel shaft hub
(see Page 129).
8. Check front suspension is loose.
9. Check steering linkage is loose.
10.
Check ball joint is loose.
Tire and wheel- wheel and tire system
Front and rear kPa
Front
109