Left Rear Shaft Hub And Bearing Assembly; Change - Geely FC Workshop Manual

Left rear shaft hub and bearing assembly

Change

Hint: changing procedure for right side is same as left side.
1. Disassemble rear wheels.
2. Disassemble rear brake caliper assemble
Disassemble two bolts and take down brake caliper.
3. Disassemble the wiring harness of rear wheel speed
sensor (equipping with ABS).
Disassemble the joint of rear wheel speed sensor.
4. Disassemble left rear brake assembly [64000137]
5. Disassemble left rear shaft hub and bearing
assembly.
Disassemble four bolts, then take down lower shaft hub and
bearing assembly.
6. Disassemble rear wheel speed sensor assembly (equipping with ABS) [67000023]
(referring to page 52)
7. Assemble rear wheel speed sensor assembly (equipping with ABS) [67000023] (referring
to page 52)
8. Assemble left rear shaft hub and bearing assembly
Use four bolts to assemble left rear shaft hub and bearing
assembly
9. Assemble wiring harness of rear wheel speed sen-
sor (equipping with ABS).
Connect the joint of rear wheel speed sensor.
Drive shaft--Left rear shaft hub and bearing assembly
129